STLINK-V3SET Microcontrollers ST STM8 and STM32 MCU USB Swim JTAG SWD Modular Stand-Alone in-Circuit Debugger Programmer (SPI, I2C, CAN, GPIOs) @XYG

Description The STLINKV3SET is a modular standalone debugging and programming probe for the STM8 and STM32 microcontrollers It is composed of a main module and a complementary adapter board The SWIM and JTAGSWD interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board The STLINKV3SET also provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART and bridge interfaces SPI I2C CAN GPIOs allowing for instance the programming of the target through bootloader The modular architecture of STLINKV3SET enables to extend its main features through additional modules such as the adapter board Supported Software STM32CubeProgrammer KEIL RVMDK IAR EWARM GCCbased IDEs Supported Devices All STM8 MCUs with SWIM interface All STM32 MCUs with JTAG SWD interface Connect to PC The STLINKV3SET should be connected to the PC via a USB MicroB cable Before connecting installupdate the IDESTM32CubeProgrammer to support the STLINKV3SET drivers STLINKV3SET adopts an STM32 F7 microcontroller supports USB20 high speed communication LED Status COM LED is blinking RED the first USB enumeration with the PC is taking place COM LED is RED communication between STLINKV3SET and the PC is established end of enumeration COM LED is blinking GREENRED data are being exchanged between the target and the PC Package Contains STLINKV3SET x1 USB type A plug to micro B plug cable x1 20pin JTAGSWD flat ribbon extra free x1 SWIM dual 4pin connectors cable extra free x1 SWIM 4pin connector to separated pins cable extra free x1